Cecilia ED-0956 constant drain pipe installation procedure

 
Drain hose entry point 

 To Install a constant drain pipe, first knock off the drain hose entry point with a large screw driver.

Open the water bucket door to remove the water bucket and feel the nipple joint of the drainage outlet.

Use Flexible PVC hose  (internal Diameter:15 mm. Thickness:2mm)
   


Nipple                            PVC Hose

 Cut a V-shape at the opening of the flexible PVC hose.
Open the back door where the water bucket access is. Feel the nipple of the 
drainage outlet of the Dehumidifier near  the upper right corner of the door.
Insert the PVC hose through the open hole into the nipple. The V-groove must be facing upward.
   

Fasten a hose clip over to secure the grip. Access of hose clip to the nipple is via the water bucket door.
  After this installation, make sure that no portion of the external PVC hose is higher than the drain hose entry point. If it is , back flow of water will occur and water will drip out into the base of the dehumidifier.

Note that the water flows out by gravity and downward flow of the hose is required for proper draining. Also ensure there is no hard bending of the soft PVC hose that causes a jam.

Back to 35 L/day dehumidifier  |  Back to Home Page